| Components |

Hazard Lamp Switch Repair proceduresInspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. AVN typeAudio typeNoDescription NoDescription 1GND1GND 2CAN _ High 2-3CAN _ Low 3- 4- 4-5Detent 5Detent 6ACC6Acc 7Battery (+)7Battery (+)8PAB Off 8PAB Off 9- 9Illumination (-)10- 10Illumination (+) 11SBR _ PS 11SBR PS 12- 12- 13Hazard lamp switch 13Hazard lamp switch 14- 14- 15IGN (+)15IGN (+)16- 16- Removal • Wrap the protective tape on the tool to disassemble with the screwdriver or remover...
Rheostat Repair proceduresInspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3...
Description Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element. It is related with Crankshaft Position Sensor (CKPS) and detects the piston position of each cylinder which the CKPS can't detect...
Replacement 1. Loosen the front door checker (B) mounting bolt. 2. Detach the clips, then remove the front door side weatherstrip (A). Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft) 3. Install in the reverse order of removal...