Hyundai Sonata: Evaporative Emission Control System / Fuel Filler Cap Description and Operation

Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

1. Cover
2. Torsion spring
3. Retainer
4. Gasket seal
5. Spring
6. Plate seal
7. Vacuum valve
8. Spring

Canister Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - " Fuel Tank") 3. Disconnect th ...

Fuel Tank Air Filter Repair procedures
Replacement 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Lift the vehicle. 3. Remove the rear-left wheel & tire and house cover. 4. Disconnec ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from ...

Hyundai Sonata LF 2014-2019 Service Manual: Rear Door Curtain Assembly Repair procedures
Replacement     Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. 1. Remove the ...

© 2018-2022 www.hsonatalf.org