| Replacement |
| 1. |
Remove the front door module.
(Refer to Front Door - "Front Door Module") |
| 2. |
To remove the front door outside handle base connector (A),
widen both sides of the lock pins in the direction of the arrow and then
push back the front door outside handle base connector.
|
| 3. |
Remove the connector (A) by pressing the locking pin and seperate the wiring harness (B) on the upper of front door latch.
|
| 4. |
Remove the front door inside handle cage (A).
|
| 5. |
Remove the front door latch assembly (A) by pulling it in the direction of the arrow.
|
| 6. |
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.
|
| 7. |
Remove the front door outside handle cable (A).
|
| 8. |
Install in the reverse order of removal.
|
Front Door Side Weatherstrip Repair proceduresReplacement 1. Loosen the front door checker (B) mounting bolt. 2. Detach the clips, then remove the front door side weatherstrip (A). Tightening torque : 16...
Rear Door..
Components and Components Location Components (1) Components (2) Components (3) Description and Operation Description The ECM (Electro Chromatic inside rear view Mirror) is intended dim the reflecting light in the rear view mirror. The forward facing sensor detects brightness of the surroundings, while the rearward looking sensor is for the light from the rear...
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the fuel tank. (Refer to Engine Control / Fuel System - " Fuel Tank") 3. Disconnect the vent hose (A). 4. Disconnect the vapor tube quick-connector (B,C)...