Hyundai Sonata: Engine Control System / Electric WGT Control Actuator Specifications

Specification
[EWGA Position Sensor]
Position
Output Voltage[V]
Operating Angle[°]
Range of Rod [mm], reference
Mechanical Close end stop Position (MCP)
4.8
0
0
Electrical Close end stop Position (ECP)
4.2
12
1.8
Electrical Open end stop Position (EOP)
1
79
16
Mechanical Open end stop Position (MOP)
0.5
90
18

[EWGA DC Motor]
Item
Specification
Coil Resistance (?)
1.44 ~ 1.96 [21°C(69.8°F)]

Electric WGT Control Actuator Description and Operation
Desrcription The Electric WGT Control Actuator is installed on the turbocharger.It operates the vain in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount by the ECM's PW ...

Electric WGT Control Actuator Schematic Diagrams
Signal Waveform Circuit Diagram ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Blind Spot Detection Unit Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper. (Refer to Body - "Rear Bumper") 3. Remove the BSD unit (A) after loosening the mounting nuts.     Take care not to separate the bracket from rear bumper when removing the BSD sensor. ...

Hyundai Sonata LF 2014-2019 Service Manual: Rear Hub Assembly Repair procedures
Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A).     Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub. Tightening torque : 88.2 ~ 107. ...

© 2018-2023 www.hsonatalf.org