| Removal and Installation |
| 1. |
Remove the drive belt.
(Refer to Timing System - "Dreve Belt") |
| 2. |
Remove the alternator.
(Refer to Engine Electrical System - "Alternator") |
| 3. |
Remove the alternator bracket (belt tunsioner) (A).
|
| 4. |
Install in the reverse order of removal. |
Troubleshooting Trouble symptomProbable causeRemedyDisplayed the warning lamp "E"(Driving is only possible with 1/ R gear)Not performed DCT learningPerform the DCT manual learning procedure.Impossible to driving with odd gearClutch actuator (Clutch motor 1 or position sensor 1 failure)Replace the clutch actuator assembly...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor. Specification Evaporator core temperature [°C (°F)]Resistance[K?]Voltage[V]-10 (14)8...