| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw.
|
| Installation |
| 1. |
Install the coil antenna and connect the 6P connector. |
| 2. |
Install the crash pad lower panel. |
| 3. |
Connect the negative (-) battery terminal. |
Immobilizer Control Unit Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3...
Ignition Switch Assembly. Repair proceduresRepair procedures Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad") 3...
Removal 1. Turn the ignition seitch OFF and disconnect the battery negative (-) cable. 2. Open the fuel filler door and then remove the filler-neck installation screw (A). 3. Lift the vehicle. 4. Remove the rear-LH wheel, tire, and the inner wheel house...
Components and Components Location Component Location 1. Back view camera2. AVN monitor Schematic Diagrams Circuit Diagram Description and Operation Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position...