| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Turn the ignition switch ON. |
| 3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Injector Description and OperationDescription The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the nozzle...
Replacement 1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the screw with torx driver (A). • When installing the bead brake, make sure that it does not come in contact with the TPMS sensor. • Be careful not to damage the TPMS sensor when installing the bead brake near the TPMS sensor...
General Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod must be inserted into the hole near the edge of the hood whenever you inspect the engine compartment to prevent the hood from falling and causing possible injury...