| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the center facia panel.
(Refer to Heating, Ventilation and Air Conditioning - "Controller") |
| 3. |
Remove the start/stop button (A) after loosening the screw (3EA).
|
| Installation |
| 1. |
Install the start/stop button. |
| 2. |
Install the center facia panel. |
| 3. |
Connect the negative (-) battery terminal. |
Inspection [Measuring Resistance] 1. Disconnect the smart cruise control switch connector from the control switch. 2. Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed). Function switchTerminalResistanceSET -3 - 5550?±5%RES +3 - 5880?±5%CANCEL3 - 5330?±5%CRUISE3 - 51...
Compession Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Make sure the oil in the crankcase is of the correct viscosity and at the correct level and that the battery is correctly charged...