| Inspection |
| 1. |
Wrap aluminum foil (A) around the tip of the tester probe (B) as shown.
|
| 2. |
Touch one tester probe to the glass antenna terminal (A) and
move the other tester probe along the antenna wires to check that
continuity exists.
|
To make an effective repair, the broken section must be no longer than one inch. |
| 1. |
Lightly rub the area around the broken section (A) with fine steel wool, and then clean it with alcohol.
|
| 2. |
Carefully mask above and below the broken portion of the glass antenna wire (B) with cellophane tape (C). |
| 3. |
Using a small brush, apply a heavy coat of silver conductive
paint (A) extending about 1/8?on both sides of the break. Allow 30
minutes to dry.
|
| 4. |
Check for continuity in the repaired wire. |
| 5. |
Apply a second coat of paint in the same way. Let it dry three hours before removing the tape. |
| 1. |
Remove the rear pillar trim.
(Refer to Body - "Rear Pillar Trim") |
| 2. |
Disconnect the antenna amp power connector (A) from the glass antenna amp.
|
| 3. |
Turn the radio ON.
Measure the voltage between terminals of the antenna amp power connector (A) and body ground (B).
|
| 4. |
Check for radio antenna wire resistance between terminals of the antenna connector (A) and body ground (B).
|
| 5. |
Check the grid lines for continuity. |
| 6. |
When a poor radio reception is not repaired through the above inspection methods, replace the amp.
If the radio reception is still poor, check the radio cable for short and radio head unit for failure. |
| 1. |
Check for continuity between the center poles of antenna cable.
|
| 2. |
Check for continuity between the outer poles of antenna cable. There should be continuity.
|
| 3. |
If there is no continuity, replace the antenna cable. |
| 4. |
Check for continuity between the center pole (A) of antenna cable and terminal of glass antenna (B). There should be continuity.
|
| 5. |
If there is no continuity, replace the antenna amplifier. |
| 6. |
Check for continuity between the center pole (A) and outer pole (B) of antenna cable. There should be no continuity.
|
| 7. |
If there is continuity, replace the antenna cable. |
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly") |
| 3. |
Disconnect the roof antenna connector (A).
|
| 4. |
Remove the roof antenna (A) after loosening a nut (B).
|
| Installation |
| 1. |
Connect the roof antenna connectors. |
| 2. |
Install the roof trim assembly.
|
Replacememt 1. Pull down rear door window glass by pressing the power window glass switch. 2. Remove the rear door belt outside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips...
Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...