Hyundai Sonata LF: General Information / Special Service Tools

Hyundai Sonata LF 2014-2019 Service Manual / Engine Electrical System / General Information / Special Service Tools

Special Service Tools
Tool (Number and name)
Illustration
Use
09373-27000
Alternator pulley remover wrench

Removal and installation of alternator pulley
09964-C1100
SCC reflector

Reflector to align the SCC radar
09964-C1200
Calibration beam

Laser to detect the center of the vehicle.
09964-C1300
Tripod

SCC reflector or vertical / horizontal laser support.

    Specifications

    Specification Ignition System Ignition Coil ItemSpecification Primary Coil Resistance (?)0.56 ± 10% [20°C (68°F)]Secondary Coil Resistance (k?)2...

    Troubleshooting

    Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requiredIgnition wiring disconnected or brokenRepair wiring, or replace as requiredRough idle or stallsIgnition wiringRepair wiring, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredEngine hesitates/poor accelerationSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as requiredIgnition wiringRepair wiring, or replace as requiredPoor mileageSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as required Charging System SymptomSuspect AreaRemedyCharging warning indicator does not light with ignition switch "ON" and engine off...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures


    On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide)     • Check that the battery cables are connected to the correct terminals...

    Hyundai Sonata LF 2014-2019 Service Manual: Blower Motor Repair procedures


    Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. 3. Replace the blower motor if it is proved that there is a problem with it...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org