| Troubleshooting |
| Ignition System |
| Symptom | Suspect Area | Remedy |
| Engine will not start or is hard to start (Cranks OK) | Ignition lock switch | Inspect ignition lock switch, or replace as required |
| Ignition coil | Inspect ignition coil, or replace as required | |
| Spark plugs | Inspect spark plugs, or replace as required | |
| Ignition wiring disconnected or broken | Repair wiring, or replace as required | |
| Rough idle or stalls | Ignition wiring | Repair wiring, or replace as required |
| Ignition coil | Inspect ignition coil, or replace as required | |
| Engine hesitates/poor acceleration | Spark plugs and spark plug cables | Inspect spark plugs / cable, or replace as required |
| Ignition wiring | Repair wiring, or replace as required | |
| Poor mileage | Spark plugs and spark plug cables | Inspect spark plugs / cable, or replace as required |
| Charging System |
| Symptom | Suspect Area | Remedy |
| Charging warning indicator does not light with ignition switch "ON" and engine off. | Fuse blown | Check fuses |
| Light burned out | Replace light | |
| Wiring connection loose | Tighten loose connection | |
| Electronic voltage regulator | If light turns off, replace voltage regulator. | |
| Charging warning indicator does not go out with engine running. (Battery requires frequent recharging) | Drive belt loose or worn | Adjust belt tension or replace belt |
| Battery cable loose, corroded or worn | Inspect cable connection, repair or replace cable | |
| Electronic voltage regulator or alternator | If light turns off, replace voltage regulator or alternator | |
| Wiring | Repair or replace wiring | |
| Overcharge | Electronic voltage regulator | If light turns off, replace voltage regulator. |
| Voltage sensing wire | Repair or replace wiring | |
| Discharge | Drive belt loose or worn | Adjust belt tension or replace belt |
| Wiring connection loose or short circuit | Inspect wiring connection, repair or replace wiring | |
| Electronic voltage regulator or alternator | If light turns off, replace voltage regulator or alternator | |
| Poor grounding | Inspect ground or repair | |
| Worn battery | Replace battery |
| Starting System |
| Symptom | Suspect Area | Remedy |
| Engine will not crank | Battery charge low | Charge or replace battery |
| Battery cables loose, corroded or worn out | Repair or replace cables | |
| Transaxle range switch (Vehicle with automatic transaxle only) | Refer to AT group-automatic transaxle | |
| Fuse blown | Replace fuse | |
| Starter motor faulty | Replace | |
| Ignition switch faulty | Replace | |
| Engine cranks slowly | Battery charge low | Charge or replace battery |
| Battery cables loose, corroded or worn out | Repair or replace cables | |
| Starter motor faulty | Replace | |
| Starter keeps running | Starter motor faulty | Replace |
| Ignition switch | Replace | |
| Starter spins but engine will not crank | Short in wiring | Repair or replace wiring |
| Pinion gear teeth broken or starter motor | Replace | |
| Ring gear teeth broken | Replace fly wheel or torque converter |
Special Service ToolsSpecial Service Tools Tool (Number and name)IllustrationUse09373-27000Alternator pulley remover wrenchRemoval and installation of alternator pulley 09964-C1100SCC reflectorReflector to align the SCC radar09964-C1200Calibration beamLaser to detect the center of the vehicle...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to “Specification” Removal 1...
Removal 1. Disconnect the negative (-) battery terminal. 2. If it is necessary to remove multifunction switch assembly, remove the steering wheel. (Steering System - "Steering Wheel") 3. Remove the steering column upper shrouds (A). (Refer to Body - "Steering Column Shroud Panel") 4...