| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the trunk lide trim.
(Refer to Body - "Trunk Lid Trim") |
| 3. |
Disconnect the back view camera connector (A).
|
| 4. |
Remove the back view camera (A) after disengaging the mounting clip.
|
| Installation |
| 1. |
Install the back view camera. |
| 2. |
Install the trunk lid trim. |
| 3. |
Connect the negative (-) battery terminal. |
Description and OperationDescription Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up...
C..
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from the low side of the #4 injector...