| Replacement |
| 1. |
Raise the vehicle, and make sure it is securely supported. |
| 2. |
Remove the wheel cap (A).
|
| 3. |
Remove the front wheel and tire (A) from front hub.
|
| 4. |
Remove the brake caliper mounting bolts and then place the brake caliper assembly (A) with wire.
[General]
[EPB]
|
| 5. |
Loosen the mount screw and then brake disc (A).
|
| 6. |
Disconnect the wheel speed sensor connector (A).
|
| 7. |
Loosen the mounting bolts and remov it.
|
| 8. |
Install in the reverse order of removal. |
Rear Hub - Carrier Repair proceduresRemoval 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it...
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when depressed succeeding times, the booster is operating properly, if the pedal height remains unchanged, the booster is inoperative...
C..