| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Loose the nuts (4EA) holding the rear combination lamp then
disconnect the connector (A) then remove the outside rear combination
lamp assembly.
|
| 3. |
Remove the bulb (A) after turnicng in the counter clock-wise direction.
|
| 4. |
Remove the inside rear combination lamp assembly (A) after loosening the nuts (3EA) and disconnecting the connector (B).
|
| 5. |
If it is necessary to replace the bulb, remove the bulb after removing the trunk lid trim. |
| 6. |
Remove the bulb (A) after separating the inside rear combination lamp assembly.
|
| Installation |
| 1. |
Install the inside combination lamp assembly after assembling the bulb. |
| 2. |
Install the rear combination lamp assembly after assembling the bulbs and connecting the lamp connector. |
High Mounted Stop Lamp Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim") 3...
Auto Lighting Control SystemSpecifications Specifications ItemsSpecificationsRated voltage5VLoadMax. 1mA (Relay load)Illuminations (LUX)501.42 ± 0.31V1002.63 ± 0.58V1503.84 ± 0...
C..
Removal [For C-MDPS Type] Must be backup the ECU data before exchanging the ECU. The backup data is stored by the VIN number. Before exchanging the MDPS motor, must be confirm the last two digit of the constant value in motor barcord...