Hyundai Sonata LF: Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	After loosening the mounting clips, then remove the rear bumper center under cover (A).

3.	Disconnect the rear bumper beam mounting wiring harness.

4.	Remove the mounting clips (A), then remove the rear bumper beam assembly (B).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damage clips.

Rear Bumper Beam Assembly Components and Components Location

C..

Front Seat

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Specifications

Specifications ItemsSpecificationHoodTypeRear hinged, gas lifter typeFront DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemRear DoorConstructionFront hinged, full door constructionRegulator systemWire drum typeLocking systemPin-fork systemTrunk LidTypeFront hinged, power trunk lid type (option)Seat BeltsFront3 point type with Emergency Locking Retractor (E...

Hyundai Sonata LF 2014-2019 Service Manual: Brake Pedal Repair procedures