Hyundai Sonata: Windows / Power Windows
The ignition switch must be in the ON position to be able to raise or lower the windows. Each door has a Power Window switch to control that door's window. The driver has a Power Window Lock switch which can block the operation of passenger windows. The power windows will operate for approximately 30 seconds after the ignition switch is placed in the ACC or LOCK/OFF position. However, if the front doors are opened, the Power Windows cannot be operated even within the 30 second period.
WARNING
To avoid serious injury or death, do not extend your head, arms or body outside the windows while driving.
Information
- In cold and wet climates, power windows may not work properly due to freezing conditions.
- While driving with the rear windows down or with the sunroof (if equipped) opened (or partially opened), your vehicle may demonstrate a wind buffeting or pulsation noise. This noise is normal and can be reduced or eliminated by taking the following actions. If the noise occurs with one or both of the rear windows down, partially lower both front windows approximately one inch. If you experience the noise with the sunroof open, slightly close the sunroof.
- Window opening and closing
- Auto up/down window. To reset the power windows
- Automatic reverse
- Power window lock switch
Windows
(1) Driver’s door power window switch
(2) Front passenger’s door power window switch
(3) Rear door (left) power window switch
(4) Rear door (right) power window switch
(5) Window opening and clos ...
Window opening and closing
To open:
Press the window switch down to the first detent position (5). Release the switch
when you want the window to stop.
To close:
Pull the window switch up to the first detent position (5). Rel ...
Other information:
Hyundai Sonata LF 2014-2019 Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS)
and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls
the injection and ignition timing by using these signals.
Generally CkPS signal is used to detect the piston's position
and CMPS signal is used to de ...
Hyundai Sonata LF 2014-2019 Service Manual: Troubleshooting
Failure Diagnosis
1.
In principle, ESP and TCS controls are prohibited in case of ABS failure.
2.
When ESP or TCS fails, only the failed system control is prohibited.
3.
However, when the solenoid valve relay should be turned off in case of ESP failure, refer to the ABS fail-safe.
4.
...
