Hyundai Sonata: Power Windows / Automatic reverse

If a window senses any obstacle while it is closing automatically, it will stop and lower approximately 12 inches (30 cm) to allow the object to be cleared.

If the window detects the resistance while the power window switch is pulled up continuously, the window will stop upward movement then lower approximately 1 inch (2.5 cm).

If the power window switch is pulled up continuously again within 5 seconds after the window is lowered by the automatic window reverse feature, the automatic window reverse will not operate.

Information

The automatic reverse feature is only active when the "Auto Up" feature is used by fully pulling up the switch to the second detent.

WARNING

Make sure body parts or other objects are safely out of the way before closing the windows to avoid injuries or vehicle damage.

Objects less than 0.16 inch (4 mm) in diameter caught between the window glass and the upper window channel may not be detected by the automatic reverse window and the window will not stop and reverse direction.

NOTICE

Do not install any accessories on the windows. The automatic reverse feature may not operate.

Auto up/down window. To reset the power windows
Auto up/down window Pressing or pulling up the power window switch momentarily to the second detent position (6) completely lowers or lifts the window even when the switch is released. To stop the w ...

Power window lock switch
The driver can disable the power window switches on the rear passenger's doors by pressing the power window lock switch. When the power window lock switch is pressed: The driver's master control c ...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Fuel Filler Door Open Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the fuel filler door open switch (A).     Take care not to scratch the crash pad surface. 3. Disconnect the fuel filler door open switch connector (A). 4. Apply ...

Hyundai Sonata LF 2014-2019 Owners Manual: Turn signals and lane change signals
To signal a turn, push down on the lever for a left turn or up for a right turn in position (A). To signal a lane change, move the turn signal lever slightly and hold it in position (B).The lever will return to the OFF position when released or when the turn is completed. If an indicator stays o ...

© 2018-2025 www.hsonatalf.org