| Replacement |
| 1. |
Completely open the movable glass using the panorama sunroof switch. |
| 2. |
Remove both sides of the decoration cover (A).
|
| 3. |
Completely close the movable glass using the panorama sunroof switch. |
| 4. |
Adjust the height of the glass by slighty loosening the screws (A).
|
| 5. |
Carefully lift up the movable glass (A) and then remove it.
|
| 6. |
Install in the reverse order of removal.
|
Repair proceduresAdjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it...
Front Glass Repair proceduresRemoval • In order to remove the front glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of the wire grip ...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4. Verify that the mode control actuator operates to the vent mode when connected in reverse...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia upper panal. (Refer to Body - "Cluster Fascia Upper Panel") 3. Remove the audio head unit (A) after loosening the screws. 4. Remove the audio head unit after disconnecting the connectors and cable (A)...