Hyundai Sonata LF: Engine Control System / ETC (Electronic Throttle Control) System Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System Description and Operation

Description

The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to receive driver input. The ECM uses the APS signal to calculate the target throttle angle; the position of the throttle is then adjusted via ECM control of the ETC motor. The TPS signal is used to provide feedback regarding throttle position to the ECM. Using ETC, precise control over throttle position is possible; the need for external cruise control modules/cables is eliminated.

1. Dry bearing
2. DC motor
3. Non-contact hall sensor
4. Gear

5. Magnet
6. Hall IC
7. Yoke
8. Stator

Schematic Diagram

Engine Control Module (ECM) Repair procedures

Removal When replacing the ECM, the vehicle equipped with immobilizer must be performed the procedure as below. [In the case of installing used ECM] 1...

ETC (Electronic Throttle Control) System Troubleshooting

F..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures

Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door window glass mounting hole plug (A)...

Hyundai Sonata LF 2014-2019 Service Manual: Important Safety Notice