Hyundai Sonata LF: Heater / Mode Control Actuator Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Heater / Mode Control Actuator Description and Operation

Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent > Bi-Level > Floor > Mix.

    Mode Control Actuator Components and Components Location

    C..

    Mode Control Actuator Repair procedures

    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Boost Pressure Sensor (BPS) Repair procedures


    Inspection 1. Connect a GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the BPS at idle and IG ON. Specification: Refer to "Specification" Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable...

    Hyundai Sonata LF 2014-2019 Service Manual: Steering Angle Sensor Repair procedures


    Adjustment Calibration (Setting up the zero angle) Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set. Calibration must be performed as following cases. - Replacement of the Steering Wheel Angle Speed Sensor - Replacement or repair of the Steering column - Detection of DTC codes (C1260, C1261) - Replacement of the sensor cluster - Replacement of HECU Calibration procedure Perform wheel alignment and stand the steering wheel in a line within ±5°error...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org