Hyundai Sonata LF: Body (Interior and Exterior) / Mirror
Outside Rear View Mirror Components and Components Location
1. Outside rear view mirror
|
|
Outside Rear View Mirror Repair procedures
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage. |
| • |
Take care not to scratch the body surface. |
|
| 1. |
After loosening the mounting clips, then remove the front door quadrant inner cover (A). 
|
| 2. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
| 3. |
Disconnect the outside rear view mirror connector (A). |
| 4. |
After loosening the mounting nuts, then remove the outside rear view mirror (B).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
|
|
| 5. |
Install in the reverse order of removal.
| • |
Make sure the connector is connected properly. |
| • |
Replace any damaged clips. |
|
|
Inside Rear View Mirror Components and Components Location
1. Inside rear view mirror
|
|
Inside Rear View Mirror Repair procedures
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage. |
| • |
Take care not to scratch the body surface. |
|
| 1. |
Remove the inside rear view mirror cover (A). 
|
| 2. |
Disconnect the inside rear view mirror connector (A). 
|
| 3. |
Push the ECM mirror base down to remove the ECM mirror assembly (A). 
|
| 4. |
Install in the reverse order of removal.
| • |
Be careful not to windshield glass. |
|
|
Removal
•
In order to remove the panorama sunroof assembly, use the tools shown in the following figure:
[Tooling Diagram]
Square wire
Insert-type wire grip
[Tooling Assembly Diagram]
•
Insert and affix square wire into the insert hole of the wire grip ...
Components and Components Location
Component Location
1. Cowl top cover
Repair procedures
Replacement
•
Put on gloves to protect your hands...
Other information:
R..
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [C500-A]
Pin No.DescriptionConnected to1Injector (Cylinder #3) [High] control outputInjector (Cylinder #3)2Injector (Cylinder #4) [High] control outputInjector (Cylinder #4)3Injector (Cylinder #2) [Low] control outputInjector (Cylinder #2)4Electric Waste Gate Actuator (EWGA) DC Motor output (+)Electric Waste Gate Actuator (EWGA) 5Heated Oxygen Sensor (HO2S) [Bank 1/Sensor 1] heater control outputHeated Oxygen Sensor (HO2S) [Bank 1/Sensor 1]6-?7-8-?9Sensor ground Electric Waste Gate Actuator (EWGA) 10-?11-?12-13-?14Cooling fan relay [High] control outputCooling fan relay [High]15CVVT Oil Control Valve (OCV) [Bank 1/Exhaust] control outputCVVT Oil Control Valve (OCV) [Bank 1/Exhaust]16Injector (Cylinder #2) [High] control outputInjector (Cylinder #2)17Injector (Cylinder #1) [High] control outputInjector (Cylinder #1)18Injector (Cylinder #3) [Low] control outputInjector (Cylinder #3)19Electric Waste Gate Actuator (EWGA) DC Motor output (-) Electric Waste Gate Actuator (EWGA) 20Heated Oxygen Sensor (HO2S) [Bank 1/Sensor2] heater control outputHeated Oxygen Sensor (HO2S) [Bank 1/Sensor 2]21-?22-?23Engine Coolant Temperature Sensor (ECTS) signal inputEngine Coolant Temperature Sensor (ECTS)?24Sensor groundEngine Coolant Temperature Sensor (ECTS) 25-?26Fuel Tank Pressure Sensor (FTPS) signal inputFuel Tank Pressure Sensor (FTPS)27Fuel pump relay control output (NON-Smart key type)Fuel pump relayCanister Close Valve (CCV) control output (Smart key type)Canister Close Valve (CCV)28-?29-30-?31Ignition coil (Cylinder #3) control outputIgnition coil (Cylinder #3)32Ignition coil (Cylinder #1) control outputIgnition coil (Cylinder #1)33Injector (Cylinder #1) [Low] control outputInjector (Cylinder #1)34Fuel Pressure Control Valve (FPCV) [High] control outputFuel Pressure Control Valve (FPCV)35ETC motor [-] control outputETC motor36-?37Knock Sensor (KS) signal inputKnock Sensor (KS)38Sensor groundKnock Sensor (KS)39-40Brake Light switch signal inputBrake switch41-42-43-?44-?45CVVT Oil Control Valve (OCV) [Bank 1/Intake] control outputCVVT Oil Control Valve (OCV) [Bank 1/Intake]46Ignition coil (Cylinder #4) control outputIgnition coil (Cylinder #4)47Ignition coil (Cylinder #2) control outputIgnition coil (Cylinder #2)48Injector (Cylinder #4) [Low] control outputInjector (Cylinder #4)49Fuel Pressure Control Valve (FPCV) [Low] control outputFuel Pressure Control Valve (FPCV)50ETC motor [+] control outputETC motor51-?52Electric Waste Gate Actuator (EWGA) Feed beck signal Electric Waste Gate Actuator (EWGA) 53Brake Test switch signal inputBrake switch54-?55-56Electric load signal input [Defrost]Alternator57Alternator COM signal outputAlternator58Engine speed signal outputCluster59Cooling fan relay [Low] control outputCooling fan relay [Low] 60-
Connector [C500-K]
Pin No...
Panorama Sunroof Assembly Repair procedures
Cowl Top Cover