| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the mounting nuts (A). |
| 4. |
Disconnect the knee airbag connector (B).
|
| Installation |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 2. |
Install the knee airbag.
|
| 3. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 4. |
Reconnect the battery negative cable. |
| 5. |
After installing the knee airbag, confirm proper system operation.
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Airbag Module Disposal Description and OperationAirbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those installed in vehicle to be scrapped), the airbags or side airbags must be deployed...
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. Specification Fan Speed (Manual)Motor Voltage (V)14...
Description The EPB is an electronic parking brake. The EPB is different from existing parking systems which operated with the brake pedal or the lever type. The EPB system sends the signal to the ECU when a driver operates the EPB switch. The ECU operates the EPB actuator composed with motor gears...