Hyundai Sonata LF: Dual Clutch Transmission Control System / Input shaft speed sensor 2 Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / DCT (Dual Clutch Transmission) System / Dual Clutch Transmission Control System / Input shaft speed sensor 2 Repair procedures

Removal
1.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechnical System - "Air cleaner")
2.
Remove the battery and tray.
(Refer to Engine Electrical System - "Battery")
3.
Remove the clutch actuator.
(Refer to Dual Clutch Control System - "Clutch Actuator")
4.
Disconnect the input shaft speed sensor (A).

5.
Remove the input shaft speed sensor after removing the bolt (A-2ea).

Installation
1.
Install in the reverse order of removal.
   
•
Before installing the input speed sensor,check the assembled state of the O-rings (A) and should apply gear oil to the surface of O- rings.

    Input shaft speed sensor 2 Schematic Diagrams

    C..

    Inhibitor Switch Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Important Safety Notice


    General Information Proper service methods and repair procedures are essential for safe, reliable operation of all motor vehicles as well as personal safety of the operator. The service procedures and descriptions in this shop manual provide general directions for a service and repair...

    Hyundai Sonata LF 2014-2019 Service Manual: Front Disc Brake Components and Components Location


    C..

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org