| Description |
| • |
Components location : DCT (Dual Clutch Transmission)
|
| • |
Function
- The inhibitor switch mounted on the upper of transaxle and connected with shifter lever.
- The inhibitor switch has four points of contact and it makes the signals(S1, S2, S3, S4).
- The inhibitor switch signals delivered at the TCM according
to control of the shift lever positions(P, R, N, D) and it is used to
control of the gear setting. |
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A). 4. Remove the ignition coil (A). • When removing the ignition coil connector, pull the lock pin (A) and push the clip (B)...
Troubleshooting SymptomSuspect AreaRemedy (Refer to page)Water leaks from panorama sunroofDirt accumulated in drain tubeClear dirt inside of drainClogged drain tubeBlow air into drain to remove dirtBroken or dislocated drain tube, defective or cracked clipCheck tube installation and flange contactDeteriorated roof lid weatherstripReplaceExcessive roof lid-to-body clearance and improperly fitted weatherstripAdjustWind noise around panorama sunroofLoosen or deformed deflector, gaps in body workRetighten adjust or replaceMisaligned weather stripReadjust or replace weather stripSunroof lid makes a noise when moveForeign particles lodged in guide railCheck drive cable and guide rails for foreign particlesLoosen guide rails and lidRetightenMotor runs but panorama sunroof does not move or moves only partiallyForeign particles lodged in guide railAdjust or replaceIncorrect engagement of motor pinion with drive cableDecrease in motor`s clutch slipping forceIncreased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc...