| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the driver crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the knee airbag module.
(Refer to Restraint - "Knee Airbag (KAB) Module") |
| 4. |
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening a nut.
|
| Installation |
| 1. |
Install the immobilizer control unit after connecting the unit connector. |
| 2. |
Install the crash pad lower panel and knee airbag module. |
| 3. |
Connect the negative (-) battery terminal. |
Repair proceduresTeaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner...
Antenna Coil Repair proceduresRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw...
Components 1. Front door inside handle cap2. Front door pull cap3. Front door trim4. Front door module5. Front door quadrant inner cover6. Front door lower channel7. Front door panel8. Front door belt inner weatherstrip9. Front door body outside weatherstrip10...
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the mounting screws (2EA)...