Hyundai Sonata LF: Body Electrical System / Windshield Deicer

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Windshield Deicer

Components and Components Location

Component Location
Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the front defroster switch, then controls relay.
When the front defroster switch is switched ON, and the engine is running with generator output, the deicer will go ON for a maximum of 20 minutes.

1. Windshield deicer relay Smart Junction Block (SJB)
2. Windshield deicer switch
3. Deicer connector
4. Windshield deiecr

Windshield Deicer Repair procedures

Inspection
1.
Remove the cowl top cover.
(Refer to Body - "Cowl Top Cover")
2.
Disconnect the windshield deicer connector (A).

3.
Check for continuity between the terminals of deicer lines.

4.
Turn the ignition switch ON and the windshield deicer switch ON, then measure the voltage between the terminals of harness side deicer connector.

OK : approx. Battery voltage (12V)

Windshield Deicer Switch Repair procedures

Inspection
1.
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuation test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point
2.
Select the "Car Model" and the system to be checked in order to check the vehicle with the tester.
3.
Select the "Smart Junction Box (SJB)" to check the windshield deicer.
4.
Select the "Current Date" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the 'Smart Junction Box (SJB)' can be checked.

5.
Select "Actuation Test", if you want to check the Smart Junction Box (SJB) data operation forcefully.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and A/C controll unit.
(Refer to Heating, Ventilation, Air conditioning - "Heater & A/C Control Unit (Dual)")
Installation
1.
Install the heater and A/C control unit.
2.
Connect the negative (-) battery terminal.

    Power Window Switch Repair procedures

    Inspection Diagnosis with GDS 1. The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS). The diagnostic system (GDS) provides the following information...

    Rear Glass Defogger

    Components and Components Location Component Location 1. Rear glass defogger relay Smart Junction Block (SJB)2. Rear glass defogger switch3. Rear glass defogger Rear Glass Defogger Printed Heater Repair procedures Inspection     Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Water pump Repair procedures


    Removal 1. Loosen the drain plug (A), and drain the engine coolant. Remove the radiator cap to drain with speed.     System is under high pressure when the engine is hot.To avoid danger of releasing scalding engine coolant, remove the cap only when the engine is cool...

    Hyundai Sonata LF 2014-2019 Service Manual: Alternator Repair procedures


    Removal 1. Disconnect the battery negative terminal. 2. Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise to loosen tension. 3. Remove the drive belt (A). 4. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable from alternator "B" terminal (C)...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org