Hyundai Sonata LF: Fuel Delivery System / Components and Components Location

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Components and Components Location

Components Location
[Fuel Tank]

1. Fuel Tank
2. Fuel Pump
3. Fuel Filter
4. Fuel Pressure Regulator
5. Canister
6. Fuel Tank Air Filter
7. Fuel Pressure Sensor (FPS)
8. Fuel Tank Pressure Sensor (FTPS)
9. Canister Close Valve (CCV)
10. Fuel Level Sender (FLS)
11. Fuel Pump Control Module (FPCM)
12. Fuel Filler Hose
13. Ventilation Hose
14. Vapor Tube
15. Fuel Pump Plate Cover
16. Fuel Tank Band

[Fuel Pump Assembly]

1. Fuel Pump Plate Cover
2. Fuel Pressure Sensor(FPS)
3. Fuel Pump Control Module(FPCM)
4. Head Assembly
5. Fuel Filter
6. Fuel Pressure Regulator
7. Fuel Pump Motor
8. Pre-filter
9. Reservoir-cup
10. Fuel Sender

[High Pressure Fuel Line]

1. High Pressure Fuel Pump
2. High Pressure Fuel Pipe
3. Delivery Pipe
4. Injector

   
Whenever the high pressure fuel pump, fuel pipe, deliverypipe, or injector is removed immediately after shutting offthe engine, an injury may be caused by the release ofhighly pressurized fuel. Release the residual pressure inthe high pressure fuel line by referring to the "Residualfuel pressure release procedure" below before removingany high pressure fuel system components.

    Fuel Delivery System

    ..

    Repair procedures

    Fuel Pressure Test (Low pressure system) 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Temperature Control Actuator Description and Operation


    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch...

    Hyundai Sonata LF 2014-2019 Service Manual: Seat Heater Repair procedures


    Inspection Front Seat Heater 1. Check for continuity and measure the resistance between terminals No 3 and No 6. Standard value Driver / Assists (cushion + back) : 1.58±10% 2. Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org