General Information
| Emergency Towing |
| - |
The operator loads the vehicle on the back of truck. This is best way of transporting the vehicle. |
| - |
The tow truck uses two pivoting arms that go under the tires
of the driving axle and lift them off the ground. The other two wheels
remain on the ground. |
| - |
The tow truck uses metal cables with hooks on the ends. These
hooks go around parts of the frame or suspension, and the cables lift
that end of the vehicle off the ground. The vehicle's suspension and
body can be seriously damaged if this method of towing is attempted.
If the vehicle cannot be transported by flat-bed, should be
towed with the wheels of the drivig axle off the ground and do the
following : |
| • |
Release the parking brake. |
| • |
Shift the Transaxle to neutral |
| • |
Release the parking brake. |
| • |
Start the engine. |
| • |
Shift to [D] position, then [N] position. |
| • |
Turn off the engine.
|


When you load the vehicle onto the tow truck, the loading angle should be smaller than 6°.
If disabled vehicle is unable to be moved, do not forcibly continue the towing. |
Lift And Support PointsGeneral Information When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting...
General Tightening Torque TableGeneral Information Tightening Torque Table Of Standard Parts BOLT (Nominal diameter)NUT (Nominal diameter) BOLT/NUT Thin screw Torque Nm (kg...
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH). Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location...
Inspection 1. Fuse inspection Mount the test fuse to the switch fuse and relay fuse part to confirm a normal joint fit. 2. Inspection of connector by each part Check to see whether or not each connector has been damaged, or terminal surge, or incomplete connection has taken place [Engine room junction box] [Stop signal electronic module] [ABS/VDC control module] 3...