General Information
When heavy rear components such as suspension, fuel tank,
spare tire, tailgate and trunk lid are to be removed, place additional
weight in the luggage area before hoisting. When substatial weight is
removed from the rear of the vehicle, the center of gravity may change
and can cause the vehicle to tip forward on the hoist. |
|
| 1. |
Place the lift blocks under the support points as shown in the illustration. |
| 2. |
Raise the hoist a few inches (centimeters) and rock the vehicle to be sure it is firmly supported. |
| 3. |
Raise the hoist to full height to inspect the lift points for secure support.
|
Warning And Caution LabelsGeneral Information 1. Radiator cap caution2. Fan caution3. Battery caution Attention SRS VehicleThis car is equipped with a supplemental restraint system...
TowingGeneral Information If the vehicle needs to be towed, call a professional towing service. Never tow vehicle with just a rope or chain. It is very dangerous...
Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s). • Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor...
Removal • Take care not to scratch the cluster fascia panel and related parts. • Eject all the disc before removing the AVN head unit to prevent damaging the DVD player's load mechanism. • Wrap the protective tape on the tool to disassemble with the screwdriver or remover...