Hyundai Sonata LF: General Information / Specifications

Hyundai Sonata LF 2014-2019 Service Manual / Restraint / General Information / Specifications

Specification
Item
Resistance (?)
Driver Airbag (DAB)
2.0 ~ 6.0
Passenger Airbag (PAB)
1.6 ~ 6.0
Side Airbag (SAB)
1.6 ~ 6.0
Curtain Airbag (CAB)
1.6 ~ 6.0
Knee Airbag (KAB)
1.6 ~ 6.0
Seat Belt Pretensioner (BPT)
1.6 ~ 6.0
Emergency Fastening Device (EFD)
1.6 ~ 6.0
Seat Belt Buckle Switch (BS)
1.6 ~ 6.0

Tightening Torques
Item
N.m
kgf.m
lb-ft
Passenger airbag (PAB)
4.0 ~ 6.0
0.4 ~ 0.6
2.9 ~ 4.4
Side airbag (SAB)
6.9 ~ 8.8
0.6 ~ 0.8
5.1 ~ 6.5
Curtain airbag (CAB)
6.9 ~ 8.8
0.7 ~ 0.9
5.1 ~ 6.5
Knee airbag (KAB)
7.8 ~ 11.8
0.8 ~ 1.2
5.8 ~ 8.7
Seat belt anchor bolt (BPT)
39.2 ~ 53.9
4.0 ~ 5.5
28.9 ~ 39.8
Front impact sensor (FIS)
7.8 ~ 10.8
0.8 ~ 1.0
5.8 ~ 7.2
Pressure side impact sensor (P-SIS)
7.8 ~ 10.8
0.8 ~ 1.0
5.8 ~ 7.2
Gravity side impact sensor (G-SIS)
7.8 ~ 10.8
0.8 ~ 1.0
5.8 ~ 7.2
SRS control module (SRSCM)
9.8 ~ 13.7
1.0 ~ 1.4
7.2 ~ 10.1

    General Information

    General Information The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the driver, passenger, side airbag and belt pretensioner in certain frontal or side collisions...

    Special Service Tools

    Special Service Tools Tool(Number and Name)IllustrationUseDeployment tool0957A-34100AAirbag deployment tool.Deployment adapter0957A-3Q100Use with deployment tool...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Rheostat Repair procedures


    Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) after disengaging the mounting clip. 4. Remove the rheostat switch connector (A)...

    Hyundai Sonata LF 2014-2019 Service Manual: Engine Coolant Temperature Sensor (ECTS) Repair procedures


    Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. 4. Check that the resistance is within the specification...

    Categories

    read more

     
    Copyright В© 2026 www.hsonatalf.org