Hyundai Sonata LF: General Information / Special Service Tools

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / General Information / Special Service Tools

Special Service Tools
Tool (Number and Name)
Illustration
Application
RKE Battery Checker
(09954-2P100)

Measuring the RKE battery voltage
Correction jig for LDWS or LKAS
(09890-3V100)

Correction of LDWS (Lane Departure Warning System) or LKAS (Lane keeping assist system)

    General Information

    General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and clean and tight connections...

    Multifunction Switch

    Specifications Specifications ItemsSpecificationsRated voltageDC 12VOperating temperature range-22 ~ +176°F (-30°C ~ +80°C)Rated loadWasherWasher : 6A (Motor load) Components and Components Location Component 1...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Troubleshooting


    Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredSpark plugsInspect spark plugs, or replace as requiredIgnition wiring disconnected or brokenRepair wiring, or replace as requiredRough idle or stallsIgnition wiringRepair wiring, or replace as requiredIgnition coilInspect ignition coil, or replace as requiredEngine hesitates/poor accelerationSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as requiredIgnition wiringRepair wiring, or replace as requiredPoor mileageSpark plugs and spark plug cablesInspect spark plugs / cable, or replace as required Charging System SymptomSuspect AreaRemedyCharging warning indicator does not light with ignition switch "ON" and engine off...

    Hyundai Sonata LF 2014-2019 Service Manual: Canister Close Valve (CCV) Repair procedures


    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV terminal 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to "Specification" 5...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org