Hyundai Sonata LF: Air Conditioning System / Refrigerant Line Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Refrigerant Line Repair procedures

Replacement
1.
If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.
2.
Disconnect the negative (-) battery terminal.
3.
Recover the refrigerant with a recovery/charging station.
4.
Remove the engine cover (A).

5.
Remove the expansion valve cover (A) after loosening the nut.
Tightening torque :
8.8 ~ 11.8 N.m ( 0.9 ~ 1.2 kgf.m, 6.5 ~ 8.7 Ib-ft)

6.
Remove the bolts and the expansion valve (A) from the evaporator core.
Tightening torque :
8.8 ~ 11.8 N.m ( 0.9 ~ 1.2 kgf.m, 6.5 ~ 8.7 Ib-ft)

7.
Loosen the bracket mounting bolt (B) from suction& liquid assembly (A).
Tightening torque :
8.8 ~ 11.8 N.m ( 0.9 ~ 1.2 kgf.m, 6.5 ~ 8.7 Ib-ft)

8.
Disconnect the A/C pressure transducer connector (A).

9.
Remove the 2 nuts, and then disconnect the discharge line (A) and liquid line (B) from the condenser.
Tightening torque :
8.8 ~ 11.8 N.m ( 0.9 ~ 1.2 kgf.m, 6.5 ~ 8.7 Ib-ft)

10.
Remove the engine room under cover.
(Refer to Engine Mechanical System - " Engine Room Under Cover")
11.
Remove the bolts, then disconnect the suction line (A) and discharge line (B) from the compressor.
Tightening torque :
8.8 ~ 11.8 N.m ( 0.9 ~ 1.2 kgf.m, 6.5 ~ 8.7 Ib-ft)
   
•
Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.

12.
Install in the reverse order of removal.
   
•
Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
•
Tighten the bolt or nut joint to the specified torque.
•
Using a gas leak detector, check for refrigerant leakage.
•
Evacuate air in the refrigeration system and charge system with refrigerant.
Refrigerant injection
Engine
Specified amount
Theta 2.4 GDI
575 ± 20 g (20.2 ± 0.70 oz.)
Theta 2.0 T-GDI
/ Gamma 1.6 T-GDI
525 ± 20 g (18.5 ± 0.70 oz.)

    Refrigerant Line Components and Components Location

    C..

    Compressor Description and Operation

    Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Description and Operation


    Description Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module). The engine operating conditions (speed, load, warm-up condition, etc...

    Hyundai Sonata LF 2014-2019 Service Manual: Components and Components Location


    Components 1.  Timing chain2.  Timing chain guide3.  Timing chain arm4.  Timing chain auto tensioner5.  Timing chain cover6.  Drive belt idler7.  Water pump gasket8.  Water pump9.  Water pump pulley10...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org