Hyundai Sonata LF: Seat Electrical / Power Seat Control Switch Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Seat Electrical / Power Seat Control Switch Repair procedures

Inspection
Diagnosis with GDS
1.
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
(1)
Self diagnosis : Checking the failure code (DTC) and display
(2)
Current data : Checking the system input/output data state
(3)
Actuator test : Checking the system operation condition
(4)
Additional function : Other controlling such as he system option and zero point adjustment
2.
Select the "Car Model" and the system to be checked in order to check the vehicle with the tester.
3.
Select the "Power Seat Module (PSM)" to check the power seat module (PSM).
4.
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the power seat module (PSM) can be checked.
Seat Control Switch
1.
With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.

[Manual Seat Control Switch]

[Power Seat Control Switch]

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front seat outer shield cover.
(Refer to Body - "Front Seat Outer Shield Cover")
3.
Remove the power seat control switch (A) after loosening the screws.

Installation
1.
Install the power seat control switch after connecting the connector.
2.
Install the front seat outer shield cover.
3.
Connect the negative (-) battery terminal.

    Power Seat Control Switch Schematic Diagrams

    C..

    Seat Heater Components and Components Location

    C..

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Center Pillar Trim Repair procedures


    Replacement [Center Pillar Lower Trim]     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...

    Hyundai Sonata LF 2014-2019 Service Manual: TPMS Sensor Description and Operation


    Configuration State 1. Driving state Sensor transmissions occur every 1 minutes and pressure is measured every 15 seconds. 2. Stationary state Sensor transmissions does not occur and pressure is measured every 60 seconds. 3. Auto learning status When driving after stopping more than 15 minutes , sensor transmissions occur every 33 seconds and pressure is measured every 10...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org