Hyundai Sonata LF: Tire Pressure Monitoring System / TPMS Sensor Description and Operation

Hyundai Sonata LF 2014-2019 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Description and Operation

Configuration State
1.
Driving state
Sensor transmissions occur every 1 minutes and pressure is measured every 15 seconds.
2.
Stationary state
Sensor transmissions does not occur and pressure is measured every 60 seconds.
3.
Auto learning status
When driving after stopping more than 15 minutes , sensor transmissions occur every 33 seconds and pressure is measured every 10.8 seconds.
4.
Off status
The TPMS sensor is not operated.
Due to stock status, does not measured pressure, temperature, battery status.
5.
Alert State :
When a 2 psi change in pressure from the last transmission occurs, transmit tire information immediately.
The pressure is measured every 2 seconds.

    Description and Operation

    Description The Tire Pressure Monitoring System (TPMS) monitors the pressure and temperature inside the tire in order to warn the driver of changes in pressure which may influence the operation of the vehicle...

    TPMS Sensor Repair procedures

    Replacement 1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the screw with torx driver (A).     • When installing the bead brake, make sure that it does not come in contact with the TPMS sensor...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Lift And Support Points


    General Information     When heavy rear components such as suspension, fuel tank, spare tire, tailgate and trunk lid are to be removed, place additional weight in the luggage area before hoisting. When substatial weight is removed from the rear of the vehicle, the center of gravity may change and can cause the vehicle to tip forward on the hoist...

    Hyundai Sonata LF 2014-2019 Service Manual: Knock Sensor (KS) Repair procedures


    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And Exhaust System� in EM group). 3. Disconnect the injector connector (A). 4. Remove the installation bolt (B), and then remove the sensor from the cylinder block...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org