| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Open the sunglass case cover from the overhead console then
remove the 2 screws holding the overhead console. Disconnect the switch
connector and Map lamp connector, and then remove the overhead console
lamp (A).
|
| 3. |
Check for continuity between the terminals. If the continuity is not as specified, replace the panoramaroof switch.
|
Panorama Sunroof Motor Repair proceduresReplacement 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim") 3. Remove the panorama sunroof motor (A) after loosening the screws and disconnecting the connector...
Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench [Hex 14] (A). Tightening torque : 4.0 ± 1.0 N.m (0.41 ± 0.1 kgf.m, 2.95 ± 0.72 lbf-ft) 3. Remove the receiver-drier (A) from condenser using a long nose plier...
Description Steering Wheel Angle Sensor detects rotating direction of the vehicle. Rotating direction detected by the sensor is communicated with HECU as CAN signal involving information about the angle through CAN communication line. HECU detects speed of the steering wheel handling and the angle with this CAN signal...