| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
| 3. |
Remove the seat back.
(Refer to Body - "Front Seat Back Cover") |
| 4. |
Disconnect the lumbar support motor connector (A).
|
| 5. |
Remove the lumbar support assembly after disengaging mounting clip (A).
|
| Installation |
| 1. |
Install the lumbar support assembly. |
| 2. |
Install the seat back cover. |
| 3. |
Install the front seat assembly.
|
| Inspection |
| 1. |
The body electrocal system can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
The diagnostic system (GDS) provides the following information.
|
| 2. |
Select the "Car Model" and the system to be checked in order to check the vehicle with the tester. |
| 3. |
Select the "Power Seat Module (PSM)" to check the power seat module (PSM). |
| 4. |
Select the "Current Data" menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the power seat module (PSM) can be checked. |
| 5. |
If you will check the power door lock operation forcefully, select "Actuation Test". |
| 1. |
Disconnect the connectors for each motor.
[Lumbar Support Motor]
|
| 2. |
With the battery connected directly to the motor terminals, check if the motors run smoothly. |
| 3. |
Reverse the connections and check that the motor turns in reverse. |
| 4. |
If there is an abnormality, replace the motors.
|
Fuel Filler DoorComponents and Components Location Component Location 1. Fuel filler door open switch2. Fuel filler door release actuator Fuel Filler Door Release Actuator Repair procedures Inspection 1...
Components and Components Location Component Location 1. Cowl top cover Repair procedures Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...
Removal 1. Disconnect the battery negative terminal. 2. Remove the battery tray. (Refer to Engine Electrical System - "Battery") 3. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 4...