| Specification |
| Item | Specification |
| Type | Hall effect sensor |
| Operation condition (°C)°F | (-40 ~ 150)-40 ~ 302 |
| Output signal (mA) | High: 11.8 ~ 16.8 |
| Low: 5.9 ~ 8.4 |
Input shaft speed sensor 1 Description and OperationDescription • Components location : DCT (Dual Clutch Transmission) • Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...
Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the nuts (4EA) holding the rear combination lamp then disconnect the connector (A) then remove the outside rear combination lamp assembly. 3. Remove the bulb (A) after turnicng in the counter clock-wise direction...
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the RCV connector. 3. Measure resistance between the RCV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: Refer to "Specification" Removal 1...