| Circuit Diagram |

Ignition Coil Repair proceduresRemoval 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A)...
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance with the air/fuel ratio. The sensor must be hot in order to operate normally...
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear package tray trim. (Refer to Body - "Rear Package Tray Trim") 3. Remove the high mounted stop lamp after disengaging the mounting clip. Installation 1. Install the rear high mounted stop lamp...