| Replacement |
| 1. |
Remove the front bumper.
(Refer to Front bumper - "Front bumper cover") |
| 2. |
Remove the head lamps [RH].
(Refer to Body Electrical System - "Head Lamps") |
| 3. |
Disconnect the connector (A), then remove the wiring mounting clips.
|
| 4. |
Remove the hood latch (A) mounting bolts.
|
| 5. |
Disconnect the hood latch cable (A) and remove the hood lower latch assembly (B).
|
| 6. |
Install in the reverse order of removal.
|
Trunk Lid..
Replacement 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the wheel cap (A). Be careful not to damage to the wheel cap (A) when removing the it. 3. Remove the front wheel and tire (A) from front hub...
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual sensor power and ground line...