Hyundai Sonata LF: Body Side Molding / Fender Garnish Repair procedures
| • |
Put on gloves to protect your hands. |
|
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage. |
| • |
Take care not to scratch the body surface. |
|
| 1. |
Using a screwdriver, remove the fender garnish (A).
| • |
Relplace the fender garnish to a new one. |
|
|
| 2. |
Install in the reverse order of removal.
| • |
Replace any damaged clips. |
|
|
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Replacement
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Other information:
Desrcription
The Electric WGT Control Actuator is installed on the
turbocharger.It operates the vain in the Waste Gate Turbocharger (WGT)
and regulates the compressed air amount by the ECM's PWM signal. This
actuator consists of a DC motor which actuates the vane, a 2-step gear
which increases torque of the DC motor, a position sensor which detects
status of the vane, an electric control unit which drives the DC motor...
Replacement
[Front Door Scuff Trim]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Rear Wheel Guard Repair procedures
Front Mud Guard Repair procedures