Hyundai Sonata LF: Body Side Molding / Front Mud Guard Repair procedures
| • |
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage. |
| • |
Take care not to scratch the body surface. |
|
| 1. |
After loosening the mounting screw, then remove the front mud guard (A) by using a screw driver. 
|
| 2. |
Install in the reverse order of removal.
| • |
Replace any damaged clips. |
|
|
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Replacement
•
When prying with a flat-tip screwdriver or use a prying trim
tool, wrap it with protective tape, and apply protective tape around the
related parts, to prevent damage...
Other information:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Removal
1...
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4.
4.
Check that the resistance is within the specification...
Fender Garnish Repair procedures
Rear Mud Guard Repair procedures