Hyundai Sonata LF: Air Conditioning System / Evaporator Temperature Sensor Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Air Conditioning System / Evaporator Temperature Sensor Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.

Specification
Evaporator core temperature
[°C (°F)]
Resistance
[K?]
Voltage
[V]
-10 (14)
8.12
3.16
0 (32)
4.85
2.53
10 (50)
2.96
1.92
20 (68)
1.87
1.41
30 (86)
1.21
1.02
40 (104)
0.81
0.73

1. Evaporator sensor (+)
2. Sensor Ground

Diagnosis With GDS
1.
The heating, ventilation and air conditioning can be quickly diagnosed failed parts with vehicle diagnostic system (GDS).
? The diagnostic system (GDS) provides the following information.
(1) Self diagnosis: Checking the failure code (DTC) and display.
(2) Current data: Checking the system input/output data state.
(3) Actuation test: Checking the system operation condition.
(4) Additional function: Other controlling such as he system option and zero point adjustment.
2.
Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.
3.
Select the 'Current data' menu to search the current state of the input/output data.
The input/output data for the sensors corresponding to the Evaporator Temperature Sensor can be checked.

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the evaporator core.
(Refer to Heater -"Evaporator Core")
3.
Pull out the evaporator temperature sensor (A) from the evaporator core.

4.
Install in the reverse order of removal.

    Evaporator Temperature Sensor Description and Operation

    Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling...

    In-car Sensor Description and Operation

    Description The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and according to this signal the control unit regulates incar temperature to intended value...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: Description and Operation


    Description The SMART KEY system is a system that allows the user to access and operate a vehicle in a very convenient way. To access the vehicle, no traditional key or remote control unit is needed. The user carries a SMART KEY FOB which does not require any conscious actions by the user (e...

    Hyundai Sonata LF 2014-2019 Service Manual: Fuel Pump Control Module (FPCM) Description and Operation


    Description The fuel pump control module (FPCM) is installed on the right side of the fuel tank on the fuel pump top plate and controls the DC motor mounted inside the low pressure fuel pump. The module compares instantaneous fuel pressure information measured by the fuel pressure sensor (FPS) with target fuel pressure information provided by the ECM and generates the desired target fuel pressure by controlling the fuel pump motor and regulating fuel flow rate in the low pressure fuel line between the low and high pressure fuel pumps...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org