| Component Location |
| [Engine Room] |

| [Interior Relay] |

Replacement When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. 1. Disconnect the negative (-) battery terminal...
Inspection 1. Check for continuity between terminals. If the continuity is not as specified, replace the hazard lamp switch. AVN typeAudio typeNoDescription NoDescription 1GND1GND 2CAN _ High 2-3CAN _ Low 3- 4- 4-5Detent 5Detent 6ACC6Acc 7Battery (+)7Battery (+)8PAB Off 8PAB Off 9- 9Illumination (-)10- 10Illumination (+) 11SBR _ PS 11SBR PS 12- 12- 13Hazard lamp switch 13Hazard lamp switch 14- 14- 15IGN (+)15IGN (+)16- 16- Removal • Wrap the protective tape on the tool to disassemble with the screwdriver or remover...