| Components |

| No | Connector A | Connector B | Connector C |
| 1 | Room lamp_output | GND | Trunk release switch_input |
| 2 | Heated handle power_IGN 2 | - | Brake switch_input |
| 3 | heated handle_output | Auto light power_output | Fog lamp switch_input |
| 4 | - | Chassis CAN (Low) | Head lamp high switch_input |
| 5 | Safety power window enable_output | Chassis CAN (High) | Light switch_input |
| 6 | - | Wiper INT volume switch_input | Wiper switch_input |
| 7 | Wiper low relay_output | Body CAN (High) | Wiper low switch_input |
| 8 | Key hole illumination_output | Body CAN (Low) | Washer switch_input |
| 9 | - | Auto light GND_output | Heated handle NTC sensor_input |
| 10 | Wiper high relay_output | RPAS LIN Communication | IGN 1 |
| 11 | Courtesy lamp_output (Assist) | - | Battery (+) |
| 12 | Courtesy lamp_output (Driver) | - | Ground |
| 13 | Ground | - | heated handle switch_input |
| 14 | Ground | Diagnosis | Key IN switch_input |
| 15 | Pocket lamp_output | PAS_input (Option) | Rear defogger switch_input |
| 16 | - | AIR BAG signal_input | RPAS off switch_input |
| 17 | - | ? ? ? ? ? ? ? ? ? ? | Ket interlock switch_input |
| 18 | Security indicator_output | Sunroof open switch_input | |
| 19 | RPAS off switch indicator_output | Blade position_input | |
| 20 | Assist seat belt indicator_output | Auto light sensor_input | |
| 21 | AV Tail lamp_output | ACC | |
| 22 | - | IGN 2 | |
| 23 | Heated handle indicator_output | ? ? ? ? | |
| 24 | - | ||
| 25 | Key solenoid_output | ||
| 26 | AT solenoid_output |
SpecificationsSpecifications ItemsSpecificationsRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-22°F ~ 167°F (-30°C ~ 75°C)Dark currentSMK : 3mA / Keyless : 3...
Failure Diagnosis 1. In principle, ESP and TCS controls are prohibited in case of ABS failure. 2. When ESP or TCS fails, only the failed system control is prohibited. 3. However, when the solenoid valve relay should be turned off in case of ESP failure, refer to the ABS fail-safe...
Replacement [Center Pillar Lower Trim] • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...