| Circuit Diagram |


Description and OperationDescription Body Control Module (BCM) Function NoItemDescription1Washer Linked Wiper - If the washer switch is pressed ON for 0.06~0.2 second with the vehicle mode in IGN2, the wiper relay is turned ON 0...
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when depressed succeeding times, the booster is operating properly, if the pedal height remains unchanged, the booster is inoperative...
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection...