Hyundai Sonata LF: Crash Pad / Center Facia Upper Panel Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Body (Interior and Exterior) / Crash Pad / Center Facia Upper Panel Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Using a screwdriver or remover, remove the center facia lower panel assembly (A).

2.	Disconnect the A/C & heater controller connectors (A).

3.	Lower the steering wheel.

4.	Using a screwdriver or remover, remove the steering column shroud upper panel (A).

5.	Using a screwdriver or remover, remove the cluster facia upper panel assembly (A).

6.	After loosening the mounting screw, then remove the center facia upper panel assembly (A).

Install in the reverse order of removal.

•	Replace any damage clips.

Center Facia Upper Panel Components and Components Location

C..

Crash Pad Garnish Assembly [RH] Components and Components Location

C..

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Fuel Pump Control Module (FPCM) Description and Operation

Description The fuel pump control module (FPCM) is installed on the right side of the fuel tank on the fuel pump top plate and controls the DC motor mounted inside the low pressure fuel pump. The module compares instantaneous fuel pressure information measured by the fuel pressure sensor (FPS) with target fuel pressure information provided by the ECM and generates the desired target fuel pressure by controlling the fuel pump motor and regulating fuel flow rate in the low pressure fuel line between the low and high pressure fuel pumps...

Hyundai Sonata LF 2014-2019 Service Manual: Rear Disc Brake Repair procedures