Hyundai Sonata LF: Engine Control System / Boost Pressure Sensor (BPS) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Boost Pressure Sensor (BPS) Repair procedures

Inspection

1.	Connect a GDS on the Data Link Connector (DLC).

Measure the output voltage of the BPS at idle and IG ON.

Specification: Refer to "Specification"

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the boost pressure sensor connector (A).

3.	Remove the installation bolt (B), and then remove the sensor.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Install in the reverse order of removal.

Boost pressure sensor installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Boost Pressure Sensor (BPS) Schematic Diagrams

C..

Engine Coolant Temperature Sensor (ECTS) Description and Operation

Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Components and Components Location

Component Location Index Engine Room [Theta 2.4 GDI] 1. Receiver-drier2. Condenser3. Service Port (High Pressure)4. Service Port (Low Pressure)5. A/C Pressure Transducer (APT)6. Compressor7. Suction & Liquid Tube Assembly8. Expansion Valve9...

Hyundai Sonata LF 2014-2019 Service Manual: Power Door Mirrors