Hyundai Sonata LF: Blower / Blower Unit Components and Components Location

Hyundai Sonata LF 2014-2019 Service Manual / Heating, Ventilation and Air Conditioning / Blower / Blower Unit Components and Components Location

Component Location

1. Blower unit assembly

Components

1. Intake actuator
2. Intake case [LH]
3. Intake door assembly
4. Air filter
5. Filter cover assembly
6. Intake inlet seal
7. Intake case [RH]
8. Intake outlet seal
9. Blower upper cover
10. Blower unit pad
11. Blower lower case
12. Resistor
13. Power transistor assembly
14. Blower pan
15. Blower motor assembly
16. Blower motor harness sub assembly

    Blower

    ..

    Blower Unit Repair procedures

    Replacement     When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage...

    Other information:

    Hyundai Sonata LF 2014-2019 Service Manual: A/C Pressure Transducer Description and Operation


    Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed. Engine ECU stops the operation of the compressor when the temperature of refrigerant line is very high or very low irregularly to optimize air conditioning system...

    Hyundai Sonata LF 2014-2019 Service Manual: Heated Oxygen Sensor (HO2S) Specifications


    Specification HO2S [Bank 1/Sensor 1] (Linear type) ItemSpecificationHeater Resistance (?)2.4 ~ 4.0 [20°C(68°F)] ItemSpecificationHeater Resistance (?)Approx. 9.0 [20°C(68°F)] HO2S [Bank 1/Sensor 2] (Binary type) A/F Ratio (?)Output Voltage(V)RICH0...

    Categories

    read more

     
    Copyright © 2026 www.hsonatalf.org