Hyundai Sonata LF: Body Electrical System / Horn

Hyundai Sonata LF 2014-2019 Service Manual / Body Electrical System / Horn

Components and Components Location

Component Location

1. Horn switch
2. Horn relay (Built - in Metal Core Block PCB)
3. Horn (Low pitch)

4. Horn (High pitch)
5. Clock spring

Repair procedures

Removal

1.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

2.	Remove the high pitch horn (A) and low pitch horn (B) after disconnect the horn connector (C) and loosening the mounting the bolt.

Installation

1.	Install the horns after connect the horn connectors.

2.	Install the front bumper cover.

Inspection

1.	The relay on the horn of this vehicle is implanted into the metal core block PCB of the engine room relay block.

The relay inserted in semi-conductor chip type on the PCB is not available for changing. The metal core boxy shall be tested by exchanging when the relay shall be changed.

Multifunction Switch

Specifications Specifications ItemsSpecificationsRated voltageDC 12VOperating temperature range-22 ~ +176°F (-30°C ~ +80°C)Rated loadWasherWasher : 6A (Motor load) Components and Components Location Component 1...

Audio

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: In-car Sensor Description and Operation

Description The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to heater control unit and according to this signal the control unit regulates incar temperature to intended value...

Hyundai Sonata LF 2014-2019 Service Manual: Under Body Body Repair

Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual Measurement Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front side member tooling hole (O25)Side cover mounting hole (O9)Front sub frame mounting boltCenter floor side member tooling hole (O11)Center floor side member tooling hole (O16)Floor under cover mounting hole (O6...