Hyundai Sonata LF: Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Hyundai Sonata LF 2014-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the HO2S connector.

3.	Measure resistance between the HO2S terminals 2 and 5 [B1/S1].

4.	Measure resistance between the HO2S terminals 3 and 4 [B1/S2].

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

[Bank 1 / Sensor 1]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

Disconnect the connector (A), and then remove the sensor (B).

Note that the SST (Part No.: 09392-1Y100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 2]

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the connector (A), and then remove the sensor (B).

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.

•	Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).

Install in the reverse order of removal.

Heated oxygen sensor installation:

39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

Heated Oxygen Sensor (HO2S) Schematic Diagrams

C..

Rail Pressure Sensor (RPS) Description and Operation

Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal...

Other information:

Hyundai Sonata LF 2014-2019 Service Manual: Alternator Repair procedures

Removal 1. Disconnect the battery negative terminal. 2. Loosen the mounting bolts (A) and then, turn the adjusting bolt (B) clockwise to loosen tension. 3. Remove the drive belt (A). 4. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable from alternator "B" terminal (C)...

Hyundai Sonata LF 2014-2019 Service Manual: Repair procedures